If you are looking for the answer of how replace car battery, you’ve got the right page. We have approximately 10 FAQ regarding how replace car battery. Read it below.
if battery is the main source of electricity of your
Ask: if battery is the main source of electricity of your car,so the car can start without battery yes or no?how and discuss.
Answer:
No
Explanation:
Here’s a straightforward fact: you need a functioning battery to make it go. After all, without battery power, your car won’t start. Your car battery provides the zap of electricity needed to put electrical components to work.
reduce reuse recycle repeir recover 1.teo replace the battery of
Ask: reduce reuse recycle repeir recover
1.teo replace the battery of his toy car
Answer:
Repair
Explanation:When Teo replaced the battery it could be because it needed to be repaired
5.Leia is setting up 417 toy cars. each car needs
Ask:
5.Leia is setting up 417 toy cars. each car needs 3 batteries to drive. how many batteries does Leia need for her cars?
Answer:1251
Step-by-step explanation:
Answer:
Leia need 1251
Step-by-step explanation:
It is given that the total no of car is 417 and she use 3 batteries for drive a car
417 × 3 = 1251
leia is setting up 417 toy cars. Each car needs
Ask: leia is setting up 417 toy cars. Each car needs 3 batteries to drive. How many batteries does Leia need for her cars?
Answer:
1,251 batteries will used in 417 toy cars
how to replace a battery of a car
Ask: how to replace a battery of a car
Answer:
Remove cables from battery terminals. …
Remove the screws or fasteners holding the battery in place; then Remove the Battery. …
Inspect the tray the old battery was resting on. …
Position your new car battery on the tray. …
Replace the screws/fasteners to the new battery to secure it in place.
Answer:
pa brainliest po:)
thanks me later
Explanation:
Step 1. Remove cables from battery terminals
For vehicles with a negative ground, loosen the nut and bolt that holds the battery cable clamp to the negative terminal (this will be labelled with a minus sign or ‘NEG’). If your car has a positive ground, you would loosen the positive cable first (your manual will tell you which your car has and the correct order for removing battery cables).
Step 2. Remove the screws or fasteners holding the battery in place; then Remove the Battery
Remember where you put the battery screws and don’t let them roll under the car. Wear gloves while carefully lifting out the battery.
Step 3. Inspect the tray the old battery was resting on
If the tray underneath is rusty or shows any corrosive deposits, dissolve a little baking soda in some water and use this solution to clean the tray. Don’t do this without putting gloves on first. This is also the time to give your battery terminals a clean.
Step 4. Position your new car battery on the tray
Double-check that it’s facing the same direction as its predecessor and is seated firmly.
Step 5. Replace the screws/fasteners to the new battery to secure it in place
The battery should now be free of any possible ‘wiggle’.
Step 6. Reconnect your battery cables in the reverse order in which you took them off
(E.g. in a negative ground car the positive cable is reconnected first). Make sure all reconnected clamps are grabbing the posts in a solid grip.
Step 7. Dispose of your old battery properly
Because batteries are toxic and corrosive they must be disposed of legally and responsibly. Special recycling centres will accept old batteries and charge you a nominal amount to dispose of them for you. Old car batteries do NOT go in your rubbish or recycling bin.
how will you observe personal safety in removing replacing batteries?
Ask: how will you observe personal safety in removing replacing batteries?
Answer:
Wear approved safety glasses or goggles and/or a face shield. Wear proper clothing to protect your face, hands and body. Make sure work area is well-ventilated. Never lean over the battery while boosting, testing or charging.
[tex]answer[/tex]
- Wear approved safety glasses or goggles and/or a face shield.
- Wear proper clothing to protect your face, hands and body.
- Make sure work area is well-ventilated.
- Never lean over the battery while boosting, testing or charging.
How energy is transformed in a battery – operated toy
Ask: How energy is transformed in a battery – operated toy car
Answer:
chemical to elictrical ata
When the 1.5v battery is replaced with a 3v battery,
Ask: When the 1.5v battery is replaced with a 3v battery, what happens?
The bulb glows brighter
description of removing and replacing Battery.
Ask: description of removing and replacing Battery.
Always remove the negative cable first. Use a wrench to loosen the nut on the black/negative (-) end of the battery. Detach the black/negative (-) cable from the battery. Detach the red/positive (+) cable from the battery.
Procedure: On how to replace the CMOS Battery.1.___________2.___________3.___________4.___________5.___________
Ask: Procedure: On how to replace the CMOS Battery.
1.___________
2.___________
3.___________
4.___________
5.___________
Answer:
1. Locate your CMOS battery.
2. Obtain battery information.
3. Remove the battery.
4. Insert the new battery.
5. Enter CMOS values.
Explanation:
hope it helps
pa brainliest po
Not only you can get the answer of how replace car battery, you could also find the answers of 5.Leia is setting, description of removing, how to replace, reduce reuse recycle, and How energy is.
